From Ubiquiti Wiki

A typical CPE WISP configuration

Author: Skyhook 27 February 2009

Content: A typical CPE configuration for WISP.

We suppose that the WISP want to use PPPoE authentication.
From AirOS device with default configuration, set parameters as see below:

• LINK SETUP Section
  • Wireless Mode: Station
  • ESSID: set according with your APs
• NETWORK Section
  • Network Mode: Router
  • WLAN IP Address: PPPoE
  • PPPoE Username: Customer_PPPoE_username
  • PPPoE Password: Customer_PPPoE_password
  • Enable NAT: on
  • Enable DHCP Server: on (and configure desired Range Start, Range End,Netmask)
  • Enable DNS Proxy: on
• ADVANCED Section
  • Incoming Traffic Limit: 2048 kbit/s (es: customer profile download up to 2 Mbits)
  • Outgoing Traffic Limit: 256 kbit/s (es: customer profile upload up to 256 kbits)
• SYSTEM Section
  • Host Name: set a customer IDentifier
  • Administrator Username: remember to change default administrative username and password

You can also customize other parameters: Wireless Security, Data rate, Logo Customization...

After customization, you can download configuration file and reuse it for different customer, simply editing customer values (PPPoE account, LAN...).