modified on 5 December 2009 at 22:38 ••• 74,472 views

RouterStation

From Ubiquiti Wiki

Jump to: navigation, search

RouterStation Board Specs

RouterStation Front
RouterStation Back

Download RouterStation Dimensions
Download RouterStation STP

1. Over all system configuration

  • CPU Atheros AR7161 MIPS 24K running @ 680MHz
  • MEMORY DDR 64MB
  • FLASH SPI 16MB
  • Three MINI-PCI Slots supports Type IIIA
  • One USB 2.0 Host
  • One UART


2. Power Supply Range 12VDC to 24VDC

  • Using Higher voltage is recommended since it will use lower current
  • Typical Power Consumption is 3W idle no radios present
  • 5W idle One Radio present
  • 7W while passing 100Mbps traffic
  • Single RJ45 "J1" Is for WAN and Passive Power Over Ethernet


3. Ethernet Interface

  • J1 Single WAN port 10/100
  • J2 Dual Lan Port 10/100
  • Ethernet Phy switch, ADMTEK "Infineon" ADM6996FC


4. Supported IO

UART J3 6 pin Header
Terminal Settings 115200 baud, 8 bits, nor parity, 1 stop bit.

Pin Out
Pin1 3.3VDC
Pin2 S_in
Pin3 NC
Pin4 NC
Pin5 S_out
Pin6 GND

USB 2.0 Host J7
5 Pin Header typical PC USB header

Pin Out
Pin1 5VDC
Pin2 D-
Pin3 D+
Pin4 GND
Pin5 GND

JTAG Port "J4"
14 Pin header

Pin Out
Pin1 TRST Pin2 GND
Pin3 TDI Pin4 GND
Pin5 TDO Pin6 GND
Pin7 TMS Pin8 GND
Pin9 TCK Pin10 GND
Pin11 RST Pin12 NC
Pin13 NC Pin14 3.3VDC

USER GPIO Header "J33"
Single Row 7 Pin Header Also next to it J5 dual row header to enable pull-up or pull-down for each GPIO user selectable in case User needs Active Low or Active High GPIO

J33 Pin out and Strapping option "place shunt to enable strapping option"

Pin Out NAME J5 STRAPPING
Pin1 GPIO_0 PULL LOW
Pin2 GPIO_1 PULL LOW
Pin3 GPIO_3 PULL LOW
Pin4 GPIO_4 PULL LOW
Pin5 GPIO_5 PULL HIGH
Pin6 GPIO_6 PULL HIGH
Pin7 GPIO_7 PULL HIGH


5. RESET BUTTON "SW4"

Uses GPIO_8 with weak pull-up, Active Low, for Resting back to factory defaults or multiple functions software dependent.


6. LED INDICATORS

LED NAME FUNCTION
D29 POWER 3.3VDC
D24 RF RADIO Act GPIO_2
DS4 WAN Link/Act
DS13 LAN1 Link/Act
DS12 LAN2 Link/Act

RouterStation Software Specs

RouterStation ships with OpenWRT Kamikaze. Ubiquiti only provides limited support for the software, but full support for the hardware.

All documentation for the use of OpenWRT can be found at the following website:

http://downloads.openwrt.org/kamikaze/docs/openwrt.html

Please look forward to a quick setup guide for a single radio setup.